6
OPERATING INSTRUCTIONS
Be sure equipment is connected to properly grounded 120 volt power supply with 15 amp circuit.
Popping
1. Turn on two switches. (Located in the chassis above the door.)
2. Allow kettle to warm for approximately 5 minutes.
3. BULK SUPPLIES: Place one measure of oil in kettle. Immediately add one measure of raw popcorn
plus seasoning salt. Pull lid closed to prevent stray kernels. (Lid is held in place by magnet directly
above the kettle.)
NOTE: Corn and Oil measures:
For a 4 ounce Popper use 1/6-1/4 cup of oil and 4 ounces (1/2 cup) of raw corn.
For an 8 ounce Popper use 1/3 cup of oil and 8 ounces (1 cup) of raw corn.
PORTION PACKS: Cut off top of plastic pack. Dump entire contents in kettle. Pull lid closed to
prevent stray kernels. Use appropriate size pre-measured pack for machine.
4. While corn is popping, keep front operator doors slightly ajar to prevent fogging. Keep hopper door at
“out” position to aid in catching stray popcorn.
5. Allow corn to pop until popping ceases, usually when 3-4 seconds lapse between pops. Then pour
remaining popped corn from kettle by rotating handle clockwise 1/3 turn and pulling downward.
6. Repeat steps 1-5 for additional batches.
7. Turn KETTLE switch to OFF position when finished preparing popcorn; POWER or LIGHT switch may
remain ON to display and heat popcorn.
KETTLE WILL BE HOT! Please be sure to avoid direct contact with the kettle during the popping
process!
Kettle Care
The Paragon exclusive popcorn kettle, with patented heater arrangement, consists of a double (two part)
unit for maximum efficiency at minimum expense with low-cost maintenance.
NOTE: To avoid heavy build-up of deposits that require specialized cleaning, please follow these
instructions:
1. Wipe, with soft towel or cloth, excess oil from exterior and interior of kettle as often as possible.
2. Excessive or careless use of popping oil may result in kettle damage.
3. Always be sure to turn KETTLE switch to OFF when popping is complete.
4. For heavily carbonized kettles, Paragon recommends the use of Kettle Cleaning Kit (part #1075).
NEVER USE WATER ON ANY PART OF THE KETTLE!
Kettle Removal
1. Make sure unit is NOT connected to a power supply. UNPLUG power cord.
2. Unplug the kettle pigtail from the socket located in the chassis of the machine (ceiling).
3. Pull the clip off the hinge pin.
4. Pull the hinge pin out of the kettle hanger to free kettle.
TO INSTALL: Reverse steps 1-4.
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels